Thermaltake MozartTX Installation Manual download pdf (Page 9)

3.4 USB 2.0 & IEEE 1394 Firewire Connection

Please consult your motherboard manual to find

out the section of "USB connection".

USB connection

3.2 Case LED Connection

On the front of the case, you can find some LEDs and switch leads

(POWER SW*1, POWER LED*1, H.D.D. LED*1, RESET SW*1)

Please consult user manual of your motherboard manufacturer, then

connect these leads to the panel header on the motherboard. These

leads are usually labeled; if not, please trace them back to the case

front to find out their source.

- POWER LED connects to your M/B at the PLED

- POWER SW connects to the PWR connector on the motherboard.

- H.D.D LED connects to the eSATA connector shown as picture(3.5)

- RESET SW connects to the RSW connector on the motherboard,

3.3 Case Open Alarm Connection

To find out the cable with 2pin

connector ("Micro SW") from the

rear of inside the chassis.

To find out the position of Chassis

Alarm on your motherboard.

(please consult your motherboard

manual)

White Wire

Black Wire

( Brank )

GND2

Data+2

Data-2

Vcc2

GND1

Data+1

Data-1

Vcc1

USB2.0

13 14

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Thermaltake MozartTX Installation Manual Page 9